Garage Floor Paint
Two-Pack Epoxy Floor Sealer (First Coat)
Two-Pack Epoxy Floor Sealer (Under Coat) - This epoxy floor paint (first coat) is designed to prepare the surface of concrete, cement and non ferrous metals. This gives an ideal base for epoxy topcoat or acts as a seal coat for bare concrete floors. Resistant to water, solvents, acids, alkalis and salts. Tough finish, and has long lasting abrasion and impact resistance. Recommended for areas receiving heavy traffic (vehicle/trucks).
Following application of the product:
Do not park vehicles or place heavy equipment on the floor for a minimum of 48 hours
Do not get the floor wet for a minimum of 7 days as this will cause bloom (discolouration)
- Coverage: 5-7 m² per litre
- Touch Drying Time: 12-16 hrs
- Recoat: 24 hrs
- Hard Drying Time: 48 hrs
- Full Cure: 7 days
Select options
This product has multiple variants. The options may be chosen on the product page
Regal Prime and Seal
Floor Paint, Anti-Slip Floor Paint, Concrete Floor Paint, Garage Floor Paint, Metal Primers & Undercoats, Regal Prime and Seal
Floor Primer made to use in conjunction with any of the Regal single pack topcoat floor paints. Not suitable for use with our epoxy topcoat floor paint.
Regal Prime and Seal is a single pack, quick drying, low viscosity, penetrating first-coat floor primer. Designed to soak into the substrate, it enhances adhesion of subsequent top coats by acting as an anchor layer between the substrate and floor paint.
Regal Prime and Seal dries with a flat finish. The colour is non specific.
- Coverage: 5-10 m² per litre
- Touch Drying Time: 2-4 hours
- Recoat: 24 hours
- Hard Drying Time: 24 hours
You might be thinking does floor paint need primer? Please read our information page 'what does floor primer do?'.
Select options
This product has multiple variants. The options may be chosen on the product page
Pumice Aggregate
Floor Paint, Anti-Slip Floor Paint, Concrete Floor Paint, Epoxy Floor Paint, Garage Floor Paint, High Build Floor Paint, Metal Top Coat Paint, Anti Slip Additives, One Coat Paint, Tools and Extras
Pumice aggregate is an extremely lightweight natural material which is mixed into the paint prior to application.
It gives a rough-profiled finish and significantly increases slip resistance.
When using, pour the pumice into the paint and mix thoroughly. After mixing, use the paint immediately. Apply the paint with a roller to achieve a consistent finish.
A natural stone alternative to plastic microbeads.
Select options
This product has multiple variants. The options may be chosen on the product page
SuperTough Aggregate
Floor Paint, Anti-Slip Floor Paint, Concrete Floor Paint, Epoxy Floor Paint, Garage Floor Paint, High Build Floor Paint, Anti Slip Additives, Tools and Extras
SuperTough Aggregate is an iron-silicate grit. With much larger particles than our Pumice Aggregate, it has a hard, sharp finish to give fantastic grip when used in conjunction with our floor paints.
To use SuperTough Aggregate, firstly apply a coat of floor paint and then liberally scatter the grit over the surface of the wet paint. Allow the floor to dry for a full 24 hours. Once dry, use a soft brush to remove the excess SuperTough Aggregate that hasn’t stuck. Then paint over the whole surface of the floor again to seal the grit in place on the floor.
Select options
This product has multiple variants. The options may be chosen on the product page
